| Actuating control | single solenoid |
| Return type | With spring/air spring return |
| Switching principle | 5/2 |
| Version | Spool valve, positive overlapping |
| Housing | Polyamide fiber-glass reinforced |
| Sealing material | Acrylonitrile butadiene rubber, Hydrogenated acrylonitrile butadiene rubber |
| Protection class | IP65 |
| Nominal flow Qn | 300 l/min |
| DC operating voltage | 24 V |
| Activation | Electrically |
| Version | Spool valve, positive overlapping |
| Activation | Electrically |
| Pilot | External |
| Sealing principle | Soft sealing |
| Blocking principle | Base plate principle, multiple |
| Working pressure min./max. | -0,9 … 10 bar |
| Control pressure min./max. | 3 … 8 bar |
| Ambient temperature min./max. | -10 … 60 °C |
| Medium temperature min./max. | -10 … 60 °C |
| Medium | Compressed air |
| Max. particle size | 40 µm |
| Oil content of compressed air | 0 … 5 mg/m³ |
| Nominal flow Qn | 300 l/min |
| Pilot control exhaust | with directional pilot air exhaust |
| Protection class with connection | IP65 |
| Protective circuit | Z-diode |
| Reverse polarity protection | Protected against polarity reversal |
| LED status display | Yellow |
| Duty cycle | 100 % |
| mounting screws | Hexalobular socket (TORX) ISO 10664-8 |
| Mounting screw tightening torque | 0,5 Nm |
| Weight | See table |
| Special Note 1 | The min. control pressure must be adhered to, since otherwise faulty switching and valve failure may result! |
| Special Note 2 | The pressure dew point must be at least 15 °C under ambient and medium temperature and may not exceed 3 °C . |
| Special Note 3 | The oil content of compressed air must remain constant during the life cycle. |
| Special Note 4 | Use only the approved oils from AVENTICS. Further information can be found in the “Technical information” document (available in the MediaCentre). |
| Special Note 5 | The pilot type (external/internal) is not implemented in the valve, but in the end plate of the valve system. |
| Material - Housing | Polyamide fiber-glass reinforced |
| Material - Seals | Acrylonitrile butadiene rubber Hydrogenated acrylonitrile butadiene rubber |
| Material - Front plate | Polyamide fiber-glass reinforced |
| Material - End plate | Polyamide |
